An alternating voltage V = 150 sin(314)t is supplied to a device which offers a resistance of 20 Î© in forward direction of electric current while preventing the flow of electric current in reverse direction. The form factor is ___________

1.0.57

2.0.318

3.1.414

4.1.57

At Î¸=Ï€/2, positive portion is __________ negative portion in power cycle.

1.greater than

2. less than

3.equal to

4.greater than or equal to

In inductor, the energy delivered by source is ____________ by inductor.

1.stored as magnetic field

2.dissipated in the form of heat

3.returned to source

4.stored as electric field

A coil of 300 turns is wound on a non-magnetic core having a mean circumference of 300 mm and a cross sectional area of 300 mm2. The inductor of the coil corresponding to a magnetizing electric current of 3 A will be?

1.37.68 Î¼H

2. 47.68 Î¼H

3.113.04 Î¼H

4.120.58 Î¼H

A current waveform is of the shape of a right angled triangle with period of t = 1 sec. Given a resistance R = 1 â„¦. The average power is __________

1.1 W

2.0.5 W

3.0.333 W

4.0.111 W

A network contains linear resistors and ideal voltage source s. If values of all the resistors are doubled, then voltage across each resistor is __________

1.Halved

2.Doubled

3.Increases by 2 times

4.Remains same

A particular electric current is made up of two component: a 10 A and a sine wave of peak value 14.14 A. The average value of electric current is __________

1.0

2.24.14 A

3. 10 A

4.14.14 A

Among the following, the active element of electrical circuit is ____________

1.Voltage source

2.Current source

3. Resistance

4.Voltage and current source both

Average power is also called?

1.apparent power

2.reactive power

3.true power

4.instantaneous power

Consider a resistive network circuit, having 3 sources of 18 W, 50 W and 98 W respectively and a resistance R. When all source act together the maximum and minimum power is ____________

1.98 W, 18 W

2.166 W, 18 W

3.450 W, 2 W

4.166 W, 2 W

Consider an electric motor having resistance of 10 Î©, 20 Î© and 30 Î© respectively. The percentage of energy dissipated by 10 Î© earthing plate is ____________

1.More than 50% of total energy

2.Less than 50% of total energy

3.Depends on the materials of the three plates

4.May be more or less than 50% of total energy

Consider the self-inductances of two coils as 12 H and 5 H. 50 % of one flux links the other. The mutual inductance is ___________

1.30 H

2.24 H

3.9 H

4.4.5 H

For a practical voltage source, which of the following is correct?

1.Cannot be less than source voltage

2.Cannot be higher than source voltage

3.Is always less than source voltage

4.Is always equal to source voltage

For a series RL circuit having L = 5 H, current = 1 A (at an instant). The energy stored in magnetic field is ___________

1.3.6 J

2.2.5 J

3.1.5 J

4.3 J

For a series RL circuit, the impedance Z = 10 â„¦ at a frequency of 50 Hz. At 100 Hz the impedance is ___________

1.10 â„¦

2.20 â„¦

3. 1 â„¦

4.More than 1 Î© but less than 10 Î© 0 â„¦

For reactive load, the power factor is equal to?

1.0

2. 1

3.2

4.3

Given a wire of resistance R â„¦. The resistance of a wire of the same material and same weight and double the diameter is ___________

1.0.5 R

2.0.25 R

3.0.125 R

4. 0.0625 R

Given two mutually coupled coils have a total inductance of 1500 mH, the self-inductance of each coils if the coefficient of coupling is 0.2 is ____________

1.325 mH

2. 255 mH

3.625 mH

4.550 mH

If a circuit has complex impedance, the average power is ______

1.power stored in inductor only

2.power stored in capacitor only

3.power dissipated in resistor only

4.power stored in inductor and power dissipated in resistor

If there are M branch currents, then we can write ___________ number of independent equations.

1.M-2

2.M-1

3.M

4.M+1

If there is complex impedance in a circuit, part of energy is ____________ by reactive part and part of its energy is ____________ by the resistance.

1.alternately stored and returned, alternately stored and returned

2.alternately stored and returned, dissipated

3.dissipated, alternately stored and returned

4.dissipated, dissipated

If we apply a sinusoidal input to RL circuit, the current in the circuit is __________ and the voltage across the elements is _______________

1.square, square

2.square, sinusoid

3.sinusoid, square

4.sinusoid, sinusoid

If we apply a sinusoidal voltage to a circuit, the product of voltage and current is?

1.true power

2.apparent power

3.average power

4.reactive power

Impedance is a complex quantity having the real part as _______ and the imaginary part as ______

1.resistance, resistance

2.resistance, reactance

3.reactance, resistance

4.reactance, reactance

In capacitor, the energy delivered by source is ____________ by capacitor.

1.returned to source

2.dissipated in the form of heat

3. stored as electric field

4. stored as magnetic field

In case of resistive load, what is the power factor?

1.4

2.3

3.2

4.1

In purely resistive circuit, energy delivered by source is ____________ by resistance.

1.dissipated in the form of heat

2.stored as electric field

3. stored as magnetic field

4.returned to source

In Reciprocity Theorem, which of the following ratios is considered?

1.Voltage to current

2.Current to current

3.Voltage to voltage

4.No ratio is considered

In superposition theorem when we consider one voltage source, all the other voltage sources are ___________

1.Shorted

2.Removed

3.Undisturbed

4. Opened

Instantaneous power is negative, when the polarities of voltage and current are of __________

1.opposite sign

2.same sign

3.voltage is zero

4.current is zero

Potential of earth is â€“ 50 V. If the potential difference between anode and cathode (earthed) is measured as 150 V, actual voltage on anode is __________

1.0 V

2.100 V

3.200 V

4.250 V

Reactive power is expressed in?

1.Watts (W)

2.Volt Amperes Reactive (VAR)

3.Volt Ampere (VA)

4. No units

The basic elements of an electric circuit are _____________

1.R, L and C

2.Voltage

3. Current

4.Voltage as well as current

The charge associated with a bulb rated as 20 W, 200 V and used for 10 minutes is ____________

1.36 C

2.60 C

3.72 C

4.50 C

The energy stored in the magnetic field at a solenoid 100 cm long and 10 cm diameter wound with 1000 turns of wire carrying an electric current of 10 A, is ___________

1.1.49 J

2.0.49 J

3.0.1 J

4.1 J

The form factor of sinusoidal alternating electric current is ___________

1.0

2.1

3.1.11

4. 1.15

The highest power factor will be?

1.1

2.2

3.3

4.4

The linear circuit element among the following is ___________

1.Capacitor

2.Inductor

3.Resistor

4.Capacitor & Inductor

The power factor is called leading power factor in case of ____ circuits.

1.LC

2.RC

3.RL

4.RLC

The power factor is the ratio of ________ power to the ______ power.

1.average, apparent

2.apparent, reactive

3.reactive, average

4.apparent, average

The power factor=?

1.sinÎ¸

2.cosÎ¸

3.tanÎ¸

4.secÎ¸

The Reciprocity Theorem is applicable for __________

1.Single-source networks

2.Multi-source networks

3.Both Single and Multi-source networks

4.Neither Single nor Multi-source networks

The Reciprocity Theorem is valid for ___________

1.Non-Linear Time Invariant circuits

2.Linear Time Invariant circuits

3.Non-Linear Time Variant circuits

4. Linear Time Variant circuits

The rms value of the sine wave is 100 A. Its peak value is ____________

1.70.7 A

2.141.4 A

3.150 A

4.282.8 A

The star equivalent resistance of 3 resistors having each resistance = 5 â„¦ is ____________

1.1.5 â„¦

2.1.67 â„¦

3.3 â„¦

4. 4.5 â„¦

The Superposition Theorem is not applicable for _________

1.Power calculation

2.Voltage calculation

3.Current Calculation

4.Both Voltage and Current calculation

The temperature coefficient of a metal as the temperature increases will ____________

1.Decreases

2.Increases

3.Remains unchanged

4.Increases and remains same

The term lagging power factor is used in which circuits?

1.RLC

2.RC

3.RL

4.LC

The time varying part in the equation of instantaneous power has frequency ________________ that of the frequency of voltage or current wave forms.

1.equal to

2.twice

3.thrice

4.four times

The two windings of a transformer have an inductor of 2 H each. If mutual inductor between them is also 2 H, then which of the following is correct?

1.Turns ratio of the transformer is also 2

2. Transformer is an ideal transformer

3.It is a perfect transformer

4.It is a perfect as well as an ideal transformer

- Microwave Engineering MCQs Set-1
- Microwave Engineering MCQs Set-2
- Microwave Engineering MCQs Set-3
- Microwave Engineering MCQs Set-4
- Microwave Engineering MCQs Set-5
- Microwave Engineering MCQs Set-6
- Microwave Engineering MCQs Set-7
- Microwave Engineering MCQs Set-8
- Network Theory Set-1
- Network Theory Set-2
- Network Theory Set-3
- Network Theory Set-4
- Network Theory Set-5
- Network Theory Set-6
- Network Theory Set-7
- Network Theory MCQs Set-7
- Audio Video Engineering MCQs set -1
- Audio Video Engineering MCQs set -2
- Audio Video Engineering MCQs set -3
- Audio Video Engineering MCQs set -4
- Audio Video Engineering MCQs set -5
- Audio Video Engineering MCQs set -6
- Audio Video Engineering MCQs set -7

Online Exam TestTop Tutorials are Core Java,Hibernate ,Spring,Sturts.The content on Online Exam Testwebsite is done by expert team not only with the help of books but along with the strong professional knowledge in all context like coding,designing, marketing,etc!