An Astronomical Unit, or AU, is the average distance between

  1. Home

Question:
 An Astronomical Unit, or AU, is the average distance between

1. The Sun and Neptune

2.The Sun and Earth

3.The Earth and the Moon

4. The Sun and Mercury

Posted Date:-2021-12-05 06:36:14

More MCQS Questions and answers

  1. A 90 Ω resistor, a coil with 30 Ω of reactance, and a capacitor with 50 Ω of reactance are in series across a 12 V ac source. The current through the resistor is
  2. An Astronomical Unit, or AU, is the average distance between
  3. During an atomic explosion, the energy released is due to
  4. In a diode, when there is saturation current, the plate resistance is
  5. In a triode valve
  6. Kepler’s 2nd law deals with
  7. Kepler’s first law states that the orbits of the planets are oval in shape or
  8. The grid voltage of any triode valve is changed from 1 volt to 3 volt and the mutual conductance is 3 x 10-4 mho. The change in plate circuit current will be
  9. Which among the following statement is the definition of a pseudoplastic liquid?
  10. A 15 Ω resistor, an inductor with 8 Ω inductive reactance, and a capacitor with 12 Ω capacitive reactance are in parallel across an ac voltage source.
  11. A 15 kΩ resistor, a 220 μH coil, and a 60 pF capacitor are in series across an ac source. What is the bandwidth of the circuit?
  12. A 6.8 kΩ resistor, a 7 mH coil, and a 0.02 μF capacitor are in parallel across a 17 kHz ac source. The coil’s internal resistance Rw is 30 Ω. The equivalent parallel resistance, Rp (eq) i
  13. A transmission line has a voltage of 24 V and a conduction current of 1.2 A. What will its receiving impedance?
  14. An inductor with a reactance of 120 Ω, a capacitor with a reactance of 120 Ω and a 24 Ω resistor are in series across a 60 V source. The circuit is at resonance. The voltage across the inductor is
  15. An oscillator employs ……………… feedback
  16. An oscillator produces……………. oscillations
  17. For a given plate voltage the plate current in a triode is maximum when the potential of
  18. If the resistance in parallel with a parallel resonant circuit is reduced, the bandwidth
  19. In a series RLC circuit that is operating above the resonant frequency the current (a)
  20. In a triode amplifier, the value of maximum gain is equal to
  21. In an LC oscillator, the frequency of the oscillator is……………… L or C.
  22. In the circuit of a triode valve, there is no change in the plate current, when the plate potential is increased from 200 volt to 220 volt and the grid potential is decreased from 0.5 volt to 1.3 volt. The amplification factor of the valve is
  23. Kepler’s second law is known as
  24. Kepler’s third law is known as
  25. Multivibrators belongs to which of the following category?
  26. Name the moderator used in the nuclear reactor?
  27. Number of secondary electrons emitted per number of primary electrons depends on
  28. The amplification factor of a triode is 20. If the grid potential is reduced by 0.2 volt then to keep the plate current constant its plate voltage is to be increased by
  29. The amplification produced by a triode is due to the action of
  30. The element with the least mass per nucleon is
  31. The energy we get in nuclear reaction comes from
  32. The farther away a planet is from the sun, the …………. it takes it to orbit the sun once
  33. The formula for Kepler’s third law is
  34. The Kepler’s first law is known as
  35. The maximum impedance of a transmission line 50 ohm and the standing wave ratio of 2.5 is
  36. The propagation constant of a transmission line with impedance and admittance of 9 and 16, respectively is
  37. The relative motion between the adjacent layers of a fluid in motion is called viscous force. Which of the flowing suits the best in the sentence?
  38. The release in energy in nuclear fission is consistent with the fact that uranium has
  39. The sinusoidal oscillator is also called
  40. The splitting of a nucleus into smaller nuclei is
  41. The standing wave ratio is 4 for a transmission line of 75 ohms. What is the value of the minimum impedance?
  42. The total impedance, expressed in polar form for a certain series RLC circuit with a 200 Hz, 15 V ac source has the following values: R = 12 Ω, C = 80 μF, and L= 10 mH is
  43. The value of input impedance for a matched line will be equal to
  44. The voltage gain by the triode depends on
  45. To tune a parallel resonant circuit to a higher frequency, the capacitance should be
  46. What do we call the maximum velocity of a fluid in a tube for which the flow remains streamlined?
  47. What happens to the viscosity of liquid with the increase in temperature
  48. What has an eccentricity of zero?
  49. What is the beneficial aspect of nuclear fission?
  50. What is the normally chosen value of the characteristic impedance of a transmission line?
  51. What is the ratio of characteristic impedance to the input impedance if the ratio of load voltage to the input voltage is given as 5
  52. What is the SI unit of viscosity?
  53. What is the value of input impedance of a quarter-wave line 50 ohm and the load impedance of 20 ohms?
  54. What is the value of negative sequence impedance?
  55. What is the value of resonant frequency if the value of C in a series RLC circuit is decreased?
  56. What is the value of the characteristic impedance of a transmission line with impedance and admittance of 16 and 9?
  57. When a neutron leaves the nucleus, it’s mass
  58. When a planet orbits the Sun, one of the foci of the elliptical orbit is
  59. Which among the below-mentioned oscillators does not adopt any kind of feedback mechanism?
  60. Which among the following parameters acts as an initiator for the operation of an oscillator in the absence of input signal?
  61. Which is the following is the correct definition of solubility?
  62. Which isotope of Uranium has the capacity to sustain the chain reaction?
  63. Which of the following atomic particles have the least mass?
  64. Which of the following is not an example for the non-sinusoidal oscillator?
  65. Which of the following oscillators cannot be used in low-frequency oscillations?
  66. Which of the following represents Kinematic viscosity?
  67. Which of the following represents viscosity?
  68. Which of the following represents viscosity?
  69. Which of these fluids has the highest viscosity?
  70. Which of these ratios gives the value of viscosity of fluid?
Search
Olete Team
Online Exam Test Top Tutorials are Core Java,Hibernate ,Spring,Sturts.The content on Online Exam Test website is done by expert team not only with the help of books but along with the strong professional knowledge in all context like coding,designing, marketing,etc!